Number Plate Fixers - 1mm Adhesive Spacer Pads

Number Plate Fixers - 1mm Adhesive Spacer Pads

• For direct surface mounting on flat surfaces only

• Clean all wax and dirt from fixing area using the cleaning sachet

• Apply 3 pads in position to reverse of number plate and remove protective film

• Minimum application temperature is 10c

• Apply firm pressure for 10 seconds to ensure good bond, full bonding strength reached after 24 hours

• Avoids holes in car

• Easy Mounting

• Invisible when fixed

The Number Plate Fixers - 1mm Adhesive Spacer Pads are for direct surface mounting on flat surface only. Ensure you clean all wax and dirt from mounting surface and reverse side of number plate using the cleaning sachet. Ensure the mounting surface is flat if not select 6mm spacer pad which will absorb minor surface differences. Apply three pads to the reverse side of plate in the positions shown on the back of packaging. Remove protective film from pads and press plate into position. Apply firm pressure for about ten seconds to ensure a good bond. Full bonding strength is reached after 24 hour and the minimum application temperature is 10c.